|
|
楼主 |
发表于 2010-11-7 20:34:33
|
显示全部楼层
root@lehoon:/var/log# pwmconfig
# pwmconfig revision 5770 (2009-09-16)
This program will search your sensors for pulse width modulation (pwm)
controls, and test each one to see if it controls a fan on
your motherboard. Note that many motherboards do not have pwm
circuitry installed, even if your sensor chip supports pwm.
We will attempt to briefly stop each fan using the pwm controls.
The program will attempt to restore each fan to full speed
after testing. However, it is ** very important ** that you
physically verify that the fans have been to full speed
after the program has completed.
Found the following devices:
hwmon0 is acpitz
hwmon1/device is thinkpad
hwmon2/device is coretemp
hwmon3/device is coretemp
Found the following PWM controls:
hwmon1/device/pwm1
hwmon1/device/pwm1 is currently setup for automatic speed control.
In general, automatic mode is preferred over manual mode, as
it is more efficient and it reacts faster. Are you sure that
you want to setup this output for manual control? (n) y
hwmon1/device/pwm1_enable stuck to 2
Manual control mode not supported, skipping hwmon1/device/pwm1.
There are no usable PWM outputs.
没有生成为什么 呀？ |
|
IP卡
狗仔卡
发表于 2010-11-6 03:56:17
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡