我全安装了redhat9,再安装scim0.81,但是glib2.2,与gtk+2.2的tar包装不了，也没有rpm包

blackant

我全装了redhat9,再装scim0.81（3个文件，主文件和chinese,table文件)时仍然提示libscim的包未装,然后按主页上的说明装，但是网上的glib2.2与gtk+2.2只有tar文件,安装时出错！

现在有2个问题，
1.glib与glib2是什么关系；
2.有没有人全装redhat9后，装scim0.81扔然要求libscim的,如果按主页的，glib及gtk+又装不了?怎么解决?


以下是主页的说明

How to install SCIM?
If you want to run SCIM under X11 (XFree86) envrionment, you should first install following dependent packages:

glib 2.0.x or above, 2.2.x is recommended.
atk 1.0.x or above, 1.2.x is recommended.
pango-1.0.x or above, 1.2.x is recommended.
gtk+2.0.x or above, 2.2.x is recommended.
if you want to use GConf Config module, you should also install the following packages:
libxml2 2.4.x or above
ORBit2 2.4.x or above
linc 0.5.x or above
GConf2 1.2.0 or above

james_su

redhat9 直接安装 scim-0.8.2-1.i586.rpm scim-chinese-0.2.6-1.i586.rpm scim-tables-zh-0.3.0-1.noarch.rpm 就可以了。gtk2, glib2 系统里面已经有了。

最初由 blackant 发表
我全装了redhat9,再装scim0.81（3个文件，主文件和chinese,table文件)时仍然提示libscim的包未装,然后按主页上的说明装，但是网上的glib2.2与gtk+2.2只有tar文件,安装时出错！

现在有2个问题，
1.glib与glib2是什么关系；
2.有没有人全装redhat9后，装scim0.81扔然要求libscim的,如果按主页的，glib及gtk+又装不了?怎么解决?


以下是主页的说明

How to install SCIM?
If you want to run SCIM under X11 (XFree86) envrionment, you should first install following dependent packages:

glib 2.0.x or above, 2.2.x is recommended.
atk 1.0.x or above, 1.2.x is recommended.
pango-1.0.x or above, 1.2.x is recommended.
gtk+2.0.x or above, 2.2.x is recommended.
if you want to use GConf Config module, you should also install the following packages:
libxml2 2.4.x or above
ORBit2 2.4.x or above
linc 0.5.x or above
GConf2 1.2.0 or above