Etch ： 无线网卡不工作

yhtt

ibm x22， 640MB，Sercom 11MB 无线网卡，在sarge，ubuntu6。10，7.04下都正常。

使用无线网络安装，一切正常。重启后无法上网。网卡两个灯亮，而且系统应该已经识别出网卡，而且得到DNS。 etc 下面的hosts hostname resovl.conf 都正常。iwconfi 输出如下：
eth1      IEEE 802.11b  ESSID:"default"  Nickname:"rism  I"

        Mode:Managed  Frequency:2.462 GHz  Access Point: 00:C0:021:64:70   

          Bit Rate:2 Mb/s   Sensitivity:1/3  

          Retry min limit:8   RTS thrff   Fragment thrff

         Encryption keyff

         Power Managementff

         Link Quality=58/92  Signal level=-42 dBm  Noise level=-143 dBm

          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0

          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

Ping不起作用，另外用系统的NetworkManager设置也没有用。

请牛老大告知应该怎样办才能够让网卡工作起来。 谢谢。

dajun

have not used this card,
but I want to know what's the price if X22 now, the standard set is PIII-800,128M ?

yhtt

Post by dajun
have not used this card,
but I want to know what's the price if X22 now, the standard set is PIII-800,128M ?

bought it second hand. Jap version, made in  mexico, quality very good, light and strong. Tualatin Piii 766, for RMB2800 here, increased to 640MB

The same NIC card has no problems for sarge and other distros.  I guess it is just a small trick that I did not find.  If anyone know, please advise. Thanks.

favoyun

看看/etc/network/interfaces文件有问题么？